Responding to an 'Alarm' Service Call

Open forum for questions from the general public (property managers, resident managers, strata owners, etc.) relating to fire prevention & fire protection issues. Advertising of services is prohibited.
Forum rules
Blatantly advertising your services is strictly prohibited. Violators will be banned from posting. Identification with a company engaged in providing fire equipment service is encouraged in order to validate responses (i.e. a "tag line" which states your name, company's name and contact information is allowed).

Responding to an 'Alarm' Service Call

Postby Zeus » Wed Dec 14, 2016 5:48

Hello everyone, 8-)

I have a quick question about a service call that I had to respond to a while ago (it was a Mircom panel). The panel was going into 'alarm' once or twice the past few days and the zone was disconnected but still in alarm upon arrival. Let's just say that it is a small building and the panel shows what zone the alarm is in. If all devices have been visually checked and there doesn't seem to be an issue (most devices were heats), what is the best and most effective way when looking for the culprit? Would it be best to clear the panel and play around with each device to see if you get an alarm? Or perhaps wire through each device (same way as 'trouble' signals) and see if the 'alarm' on the panel disappears? Hope to hear from you guys/girls soon.

Thank you,

Zeus (Full CFAA certified but still a bit fresh in the industry)
Last edited by Zeus on Sun Dec 18, 2016 7:28, edited 2 times in total.
Zeus
 
Posts: 4
Joined: Mon Dec 12, 2016 6:39

Re: Responding to an 'Alarm' Service Call

Postby FIRETEK » Sat Dec 17, 2016 9:53

A "visual" inspection of the automatic detectors might not be sufficient if you're experiencing repeated alarm events from the zone. You may have to drop each device and check for water/corrosion or a loose or pinched wire. In the latter case, the heats closest to a hood could be subject to vibration events that might result in an intermittent contact. Start from there. There's no really easy solution for a conventionally wired fire alarm system, unfortunately. :cry:
Frank Kurz
http://www.firetechs.net
1 (888) 340-3473
FIRETEK
Site Admin
 
Posts: 69
Joined: Sat Aug 23, 2008 9:10
Location: Vancouver, B. C., Canada


Return to Ask a Tech!

Who is online

Users browsing this forum: No registered users and 0 guests

cron